Tactical Scorpion Gear IDPA 2/3 AR500 Steel 12" x 20" X 1/4" Shooting Target

Description: Tactical Scorpion Gear AR500 12″ x 20″ 2/3 scale IDPA 1/4″ steel shooting target Two 5/8″ mounting holes and one square hole to accept 1/2″ carriage bolt Hang from both holes for more stability but you can hang from the single square hole We utilize a CNC laser cutting table for the cutting of all our AR500 products. Plasma cutting cuts slowly, this puts a lot of heat into the steel. ( Submerged plasma cutting machine is no better) This excess heat can result in excessive chipping and damage near the cut edge during use and easily shattering when shot. Plasma cutting generates large amounts of heat that is deposited into the target, softening it’s edges. The heat-affected zone (HAZ) generated by plasma cutting is the largest out of the most commonly used methods for cutting abrasion resistant steel. Most AR500 is cut with plasma cutters as they are cheap and relatively small compared to other methods. Superior Material : AR500 1/4″ steel with 477 – 550 BHN Minimum surface hardness of 477 BHN. Core hardness 450 min BHN 1/4" AR targets are used for Handguns should be used no closer than 10 yards For velocities over 3000fps MV use at 200 yards minimum. Handguns should be used no closer than 10 yards . Be sure you have a downward angle to direct splatter away from shooter towards the ground. All targets are raw and unfinished All of our 1/4″ targets carry a limited lifetime guarantee from breakage Part number: TSG-GG1220 Size: 12″x 20″ X 1/4" 2/3 scale IDPA target Package Contents: One 12″ x 20″ Ar500 steel Target Disclaimer: Purchaser assumes all liability for the use of the targets . Do not use AP or Steel Core ammunition this is very dangerous and will damage your target.

Price: 56.66 USD

Location: Goldsboro, North Carolina

End Time: 2024-03-15T14:21:34.000Z

Shipping Cost: 0 USD